Try Asking Eddy!
Electric Motor Repair Tips
Adjusting End Play on Vertical Pump Motors
How to Measure Magnet Wire
How to Perform an Insulation Resistance (IR) Test
How to Set Brush Neutral on a DC Machine
Lubricating an Open Ball Bearing During Assembly of an Induction Motor
Measuring a Bearing Journal
Performing a Single-Phase Rotor Test on an Assembled Three-Phase Induction Motor
Seating Carbon Brushes on a DC Machine
Testing Interpole Polarity on a DC Machine
Using an Induction Heater to Install Interference-Fit Bearings
Archive: EASA Training Films
NOTE: These training films are archived here solely for historical purposes. The films were produced many years ago and they do not meet EASA's current presentation standards. Some procedures may have also changed. Note that Film #6 was withdrawn.
Training Film 1: Taking Winding Data from a Three-Phase Induction Motor
Training Film 2: Disassembly of a Three-Phase Induction Motor
Training Film 3: Machine Winding Three-Phase Random-Wound Coils
Training Film 4: Winding a Three-Phase Stator
Training Film 5: Assembly of a Three-Phase Induction Motor
Training Film 7, Part 1: Manufacturing Form Coils (Loop Winding and Coil Forming)
Training Film 7, Part 2: Manufacturing Form Coils (Insulating Form Coils)
Training Film 8: Winding Stators With Formed Coils
Training Film 9: Taking Data From a Single-Phase Motor
Training Film 10: Disassembly of a Single-Phase Capacitor Motor
Training Film 11: Winding Single-Phase Concentric Coils
Training Film 12: Winding a Single-Phase Stator
Training Film 13: Assembly of a Single-Phase Capacitor Motor
Training Film 14: Taking Data From a Hand-Wound DC Armature
Training Film 15: Hand Winding a DC Armature
Training Film 16: Disassembly of a DC Machine
Training Film 17: Assembling a DC Machine
Training Film 18: Random-Winding DC Field Coils
Training Film 19: Layer-Winding DC Field Coils
Training Film 20: Testing Three-Phase, AC Motors Rated 600 Volts or Less
Training Film 21: Testing DC Machines